Failure performance of pcb relay products

A pcb relay product is an electrical control device, which is an electrical appliance that causes the controlled quantity to undergo a predetermined step change in the electrical output circuit when the change in the input quantity (excitation quantity) meets the specified requirements. It has an interactive relationship between the control system (also called the input loop) and the controlled system (also called the output loop). Usually used in automated control circuits, it is actually an "automatic switch" that uses a small current to control the operation of a large current. Therefore, it plays the role of automatic adjustment, safety protection, and conversion circuit in the circuit.

1. The pcb relay products are not disconnected.

1) The load current is greater than the rated switching current of the SSR, which will permanently short-circuit the relay. At this time, an SSR with a larger rated current should be used.
2) Under the ambient temperature where the relay is located, poor heat dissipation of the current it bears will damage the output semiconductor devices. At this time, a larger or more effective heat sink should be used.
3) The line voltage transient causes the output of the SSR to pass through. At this time, an SSR with a higher rated voltage should be used or an additional transient protection circuit should be provided.
4) The line voltage used is higher than the rated voltage of the SSR.
5) The parameters of pcb relay products are unstable.